You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm new to building and SMD components to pcb and have run into a problem trying to load the firmware to the STM-32 module. Attached is a photo of the error I'm running into, plus the front and back of the Exixe-12 board I soldered the components onto (maybe I messed that up).
Hoping someone can help me out or point me in the right direction.
The text was updated successfully, but these errors were encountered:
I solved this on my own. The cables that came with my ST-LINK V2 clone were too long at 18cm. I cut all the wires down to 10cm and reconnected them between the ST-LINK V2 and the Exixe12 board and launched STM32 ST-LINK Utility and it immediately connected to the target
I'm new to building and SMD components to pcb and have run into a problem trying to load the firmware to the STM-32 module. Attached is a photo of the error I'm running into, plus the front and back of the Exixe-12 board I soldered the components onto (maybe I messed that up).
Hoping someone can help me out or point me in the right direction.
The text was updated successfully, but these errors were encountered: