You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi,
I have installed the new C6 adapter in my Vaillant arotherm ebus network. I use an ethernet connection with W5500. I have a connection to the adapter and can configure it without problems using the web interface. However, it notifies that there is no eBUS signal. The ebus itself is actually working properly, as I have a proper connection to the myVaillant App and also to the HA integration via myVaillant. I have also measured the cabling on the soldering of the ebus plug of the board. Everything fine.
I have also tried out the workarounds mentioned for the V5 (switching to USB serial), but no success. When setting ebus -v in the REPL it prints
init_ebus: detected: no edges
ebus: history: @-1465323 <00
The adapter seems to send some pings or similar. The blue led blinks.
HA ebusd connection seems to be fine. It works but there are of course no entities as the bus connection is not established.
Any ideas???
The text was updated successfully, but these errors were encountered:
Hi,
I have installed the new C6 adapter in my Vaillant arotherm ebus network. I use an ethernet connection with W5500. I have a connection to the adapter and can configure it without problems using the web interface. However, it notifies that there is no eBUS signal. The ebus itself is actually working properly, as I have a proper connection to the myVaillant App and also to the HA integration via myVaillant. I have also measured the cabling on the soldering of the ebus plug of the board. Everything fine.
I have also tried out the workarounds mentioned for the V5 (switching to USB serial), but no success. When setting ebus -v in the REPL it prints
init_ebus: detected: no edges
ebus: history: @-1465323 <00
The adapter seems to send some pings or similar. The blue led blinks.
HA ebusd connection seems to be fine. It works but there are of course no entities as the bus connection is not established.
Any ideas???
The text was updated successfully, but these errors were encountered: