Skip to content

µCNC v1.2.4
Compare
Choose a tag to compare
@Paciente8159 Paciente8159 released this 10 Dec 23:53
· 2515 commits to master since this release
v1.2.4
00149fd

Version 1.2.4 is a minor revision and improves a couple of functionalities.
The following things were changed:

Added

  • new set of settings commands to control EEPROM/Flash storing (optional build setting ENABLE_SETTING_EXTRA_CMDS in cnc_config.h active by default) (#70)

    This set of new commands allow a more granular control over the settings stored in EEPROM/Flash to prevent wearing.
    When enabled all grbl $x=val are only changed in SRAM. To set them in non volatile memory a save command must be issued.
    3 additional commands are added:
    $SS - Settings save. This stores all values to EEPROM/Flash
    $SL - Settings load. This loads all values from EEPROM/Flash
    $SR - Settings reset. This loads all default values from ROM

Changed

  • enabled Grbl startup emulation to improve µCNC compatibility. Many Grbl interfaces expect the grbl startup message and won't recognize µCNC because of that simple fact (#70)
  • changed tinyUSB config and descriptors file location and updated makefile for STM32 (#70)
Assets 4
Loading