Transition from gap infill to additional contour creates a bad transition layer

[Elfe]

Version

2.2.0+linux-x64 (AppImage)

Operating system type + version

Arch Linux

3D printer brand / version + firmware version (if known)

Prusa i3 MK2

Behavior

Slicing the model creates a bad transition from gap infill to an additional outer wall.
The transition layer has some areas with nothing, some with additional outer wall and some with gap infill.
Thin wall detection just moves the transition layer to a different height.

Expected would be a better switch from layers with gap infill to a layer with additional outer walls.
Actually you get a layer that prints rather poorly.

Project File (.3MF) where problem occurs

bugged.zip

[rtyr]

Similar to #2666, #3025, #4106, #1806, #1723, #3822, etc.